DealersEdge Professional Forums

Do any of you have function GMSO running in a jobstack? GMSO may not be available for you to run from a function prompt. Up until a couple weeks ago we had this running in a jobstack, now it appears that it can no longer be added back to the jobstack. The function runs and give a printout of the RIM stock order transfer in number of lines and if any lines were not properly transferred. This saves us in case there was a transfer problem. Do we have to have it - No. Is it nice to have as a double check -YES.

If you have recently added this to your jobstack how did you do it. CDK level 2 support says it cannot be done. Yet, since the beginning of RIM, we have had this running. We were added to RIM late in the pilot phase so maybe 15 years or so???

I have that report print every morning at 08:00 AM so it must still be in my Job Stack. I don't have access to GMSO as a function. I went to look at the jobs in my Job Stack but was afraid I would somehow mess something up and lose this report. I have been on CDK for about 7 years.

I have access to GMSO as a function and run it daily to check for RIM eff ups.
I do not have it set up to run in a job stack.

drapp wrote:Do any of you have function GMSO running in a jobstack? GMSO may not be available for you to run from a function prompt. Up until a couple weeks ago we had this running in a jobstack, now it appears that it can no longer be added back to the jobstack. The function runs and give a printout of the RIM stock order transfer in number of lines and if any lines were not properly transferred. This saves us in case there was a transfer problem. Do we have to have it - No. Is it nice to have as a double check -YES.

If you have recently added this to your jobstack how did you do it. CDK level 2 support says it cannot be done. Yet, since the beginning of RIM, we have had this running. We were added to RIM late in the pilot phase so maybe 15 years or so???

I'll help you if you help me Here is how to add it to the job stack.

To add a Stock Order or State Code report to the JOB-STACK, it is necessary to follow the steps listed below. NOTE: There are special names for the reports for running in the JOB-STACK. GMSO is renamed as GMSOJS and GMSC is renamed as MSCJS. You must use these report names when setting these reports up to run in a JOB-STACK. If you still need help, tell CDK to refer to HR510D User Guide.

So here is how you can help me. I don't have access to CDK anymore but looking to see if the GM RIM State Code is displayed in Part Maintenance anywhere? Is it a reportable item in RPG in the PART-NO. file?

Thanks in advance