Page 1 of 1
13507374 bad stock?
Posted:
Thu Oct 29, 2020 8:05 pmby Parts007
13507374 GM hub/brg. I have 9 on the shelf. 2010 Lacrosse. All 9 wouldn't fit. Splines were slightly different than what came off. I ordered the AcDelco Advantage Hug Brg and it fit.
i already filed a case with Partech and RFI.
Anyone else experience this?
Re: 13507374 bad stock?
Posted:
Fri Oct 30, 2020 11:57 amby mdishong
No, but only sold 2 this month
Re: 13507374 bad stock?
Posted:
Fri Oct 30, 2020 12:53 pmby PartsPlant81
Sold 3 here this month. No issues.
Re: 13507374 bad stock?
Posted:
Fri Oct 30, 2020 1:35 pmby olepartsguy
WE HAD THE SAME SITUATION WITH A HUB ON A OLDER IMPALA . SAME THING WITH THE SPLINES.
WE PURCHASED A TIMKEN FROM LOCAL AUTO PARTS . THAT DID THE TRICK
Re: 13507374 bad stock?
Posted:
Fri Oct 30, 2020 1:40 pmby Lutom
Was it a rear bearing? We ran into the same thing on an Impala and checked engineering notes and found:
PART NUMBER 13585741. HUB ASSEMBLY. THE STUD PLATE. IS CORRECT AT APPROXIMATELY. 12 MILLA METERS THICK. AND WILL NO LONGER FIT MODEL YEAR 2005 TO 2010 IMPALA. THERE IS NO ALTERNATE AVAILABLE.
The Delco bearings still work fine.
Re: 13507374 bad stock?
Posted:
Fri Oct 30, 2020 2:21 pmby C8RFAN
I sold 4 in October, no issues here with any of my 4.
Odd
Re: 13507374 bad stock?
Posted:
Fri Oct 30, 2020 7:46 pmby Denise Trimble
There is quite the broad spectrum of applications on this one! We've sold at least a dozen this year, only one on a Regal, and one on a Lacrosse. Both went on ok. Wonder if the axle has been changed at some point?
Re: 13507374 bad stock?
Posted:
Mon Nov 02, 2020 1:24 pmby Parts007
Denise Trimble wrote:There is quite the broad spectrum of applications on this one! We've sold at least a dozen this year, only one on a Regal, and one on a Lacrosse. Both went on ok. Wonder if the axle has been changed at some point?
I am going to test that theory on the next vehicle with that application.