DealersEdge Professional Forums

HAS ANYONE SEEN THE NEW BULLETIN STATING THAT WE HAVE TO CUT THE PIPES OFF CONVERTERS?
IT LOOKS LIKE WE HAVE TO CUT MORE OF THE PIPE THEN PREVIOUS.
ANOTHER THING WE HAVE TO DO SO GM CAN SAVE MONEY.
ACCORDING TO THE BULLETIN THAT MY DM SHARED WITH ME SAYS THAT ALL THE EXTRA PIPES ARE TAKING TO MUCH ROOM IN THE CONTAINER THAT THEY USE TO SHIP.

Do you have the bulletin number? I don't see anything about that change.

Thanks!

it is a powerpoint presentation before the bulletin.

It's in the parts P&P located in Global Connect. I just found out on my own, after logistics returned an entire core return (13 pcs).

They've always had the 5' rule until this. We've always tried to make ours fit into totes, if possible, to avoid losses.

Denise Trimble wrote:They've always had the 5' rule until this. We've always tried to make ours fit into totes, if possible, to avoid losses.

We do the same as Denise does. We make it so they fit in a tote.

IN MY 10 YEARS HERE I HAVE HAD TO CUT AROUND A DOZEN.WHICH I ALWAYS THOUGHT WAS BULLSHIT. IT IS ENOUGH THAT WE DONT GET A PROCESSING FEE AND WE DO THIS FOR FREE. I HAVE ADHERED TO THE 5FT RULE. I SELL A LOT OF CONVERTERS THAT I SENT BACK WITHOUT CUTTING THEM USING THAT 5 FT RULE, BUT TO CUT MOST OF THE ONES I SELL IS RIDICULOUS. WHEN IT IS ONE OUT OF 50 I USED TO HAVE TO CUT. I KNOW I WILL CRY A LITTLE BIT AND THEN BRING IN A GRINDER FROM HELL AND HAVE SOME FUN CUTTING PIPES.

WHAT PAGE IS IT ON IN P&P HAVING A HARD TIME FINDING IT.