DealersEdge Professional Forums

Posted: **Tue Jun 03, 2014 4:38 pm**

Any Acura Parts Managers out there? Would love to pick your brain on a few questions.

Posted: **Tue Jun 03, 2014 4:42 pm**

I'm a Honda Parts Manager. If you are looking for policy and procedure information, most things are the same between the two.

Posted: **Tue Jun 03, 2014 5:07 pm**

MIKEGRNWD wrote:Any Acura Parts Managers out there? Would love to pick your brain on a few questions.

Can't say as I blame you in the least!! Hope it works out for you. I am considering a Good Chear Truck in Nome Alaska, Slightly seasonal but what the hell, refridgeration cost will be kept low!!!
On the side note, best of luck in your new venture!!!

Posted: **Tue Jun 03, 2014 8:44 pm**

pmhonda wrote:I'm a Honda Parts Manager. If you are looking for policy and procedure information, most things are the same between the two.

Any webites you could pass on that has the policy and procedures or any other sites that would help me get a jump start before I start my new job?
Thanks in advance!!!!

Posted: **Wed Jun 04, 2014 12:32 pm**

Everything that you are going to need is in the Acura/Honda interactive network. The dealer should be able to set up for you to have access before you start. Unfortunately there is not a whole lot that you can do without access to that.

Posted: **Fri Jul 25, 2014 12:35 am**

I am an Acura parts manager for about 6 years now. If you have any questions please feel free to email me
Partsmgr@crownacura (dot)ca
one major tip I can share is always check your vin
And watch out for us vehicles vs Canadian ones as there are surprisingly a fair number of differences
Good luck !! And the product is fabulous !! ( I've owed two so far )

DealersEdge Professional Forums

GETTING OUT OF GM- GOING TO ACURA

GETTING OUT OF GM- GOING TO ACURA

Re: GETTING OUT OF GM- GOING TO ACURA

Re: GETTING OUT OF GM- GOING TO ACURA

Re: GETTING OUT OF GM- GOING TO ACURA

Re: GETTING OUT OF GM- GOING TO ACURA

Re: GETTING OUT OF GM- GOING TO ACURA