Page 1 of 1
New to ADP...Is there a way..???
Posted:
Fri Jun 28, 2013 2:32 pmby dave1959
Is there a way in ADP to print out a complete report of all setup's and specifications >>?? Sources,price codes, price matrix ect..??
I know I can do them individually but complete report would be easier.. R&R has this function so I am hoping ADP does also..
Re: New to ADP...Is there a way..???
Posted:
Sun Jun 30, 2013 12:05 amby drapp
If you are looking for a single report that would show all of the system settings, the simple answer - as far as I know - is 'NO'
Re: New to ADP...Is there a way..???
Posted:
Thu May 15, 2014 2:35 pmby erikw
Don't expect the same functionality in ADP as you had with R&R. It's like night and day. ADP is good for the front end but as far as fixed ops goes, it's junk. Only my opinion, of course.
Re: New to ADP...Is there a way..???
Posted:
Tue Jun 03, 2014 4:36 pmby Mike Nicholes
If you are on Drive, the report you start with is IRO, if you are not on Drive, use the following trail: AM, MNT, Option 1, All sources. Then call ADP and ask their "service support" the same questions; keep track of whom you talk to and the instructions you are given, they may vary from contact to contact.
Mike Nicholes