Inventory cost

[daliydriver]

Yikes mine jumped 15% at the first of the may, any ADP guys know how to point me to the right report? Thanks

[always-learning]

Did you look at your appreciation first and see if anything jumps out at you? I usually have a part's update that I overrode the cost/qty (Freon, pag oil, dexos etc) where the qty stays the same but the cost updates to the bulk amount.

If that doesn't help I look at my Annual Activity & Benchmark trend report in DSDA to see which sources jumped. I've had some key punch errors that were fairly easy to locate once I knew which source I needed to look at.

[daliydriver]

Found it dexcool keeps jumping back to full 55 gallon priceing.

[TimK]

Go into PM and set the Update Code to NU.

It will no longer update the pricing.

You will have to check the pricing monthly through GM so you can change it if it changes.

[Richard]

R134A, and Y1234 do that too, watch them close and set them to NU

[marko65]

WHEN YOU SET SOMETHING TO (NU) in ADP YOU CAN NOT TAKE THE NU OFF, UNLESS YOU DELETE (WHICH DOES NOT DELETE TILL END OF MONTH) AND THEN ADD BACK AT BEGINNING OF MONTH. I HAVE STICKY NOTES AROUND MY MONITOR TO DO THAT ON A FEW PART NUMBERS. ONCE IN A WHILE I FORGET TO DO THAT AT END OF MONTH, SO I HAVE TO WAIT ANOTHER MONTH TO DO SO.